Programable Features :
- Dead Band Width
- Direction of Rotation
- Speed of Rotation (slower)
- End Points (up to 180 degrees)
- Neutral Points
- Fail Safe On/Off
- Fail Safe Points
- Resolution (default is set at high)
- Overload Protection (default is off)
Control System : +Pulse Width Control 1500usec Neutral
Required Pulse : 3-5 Volt Peak to Peak Square Wave
Operating Voltage Range : 4.8-7.4 Volts
Operating Temperature Range : -20 to +60 Degree C (-4F to +140F)
Operating Speed (6.0V) : 0.21 sec/60° at no load
Operating Speed (7.4V) : 0.17 sec/60° at no load
Stall Torque (6.0V) : 500oz/in. (36kg.cm)
Stall Torque (7.4V) : 611oz/in. (44kg.cm)
Operating Angle : 45 Deg. one side pulse traveling 400usec
Continuous Rotation Modifiable : Yes
Direction : Clockwise/Pulse Traveling 1500 to 1900usec
Idle Current Drain (6.0V) : N/A (Testing Now)
Current Drain (4.8V) : N/A (Testing Now)
Current Drain (6.0V) : N/A (Testing Now)
Dead Band Width : 1usec
Motor Type : Coreless Carbon Brush
Potentiometer Drive : 6 Slider Indirect Drive
Bearing Type : Dual Ball Bearing MR106
Gear Type : Titanium Gears
Connector Wire Length : 11.81" (300mm)
Dimensions : 1.72" x 0.88"x 1.57" (43.8 x 22.4 x 40mm)
Weight : 2.76oz (78.2g)